microsoft wireless mouse 3500 connect button

The red light will flash flash more slowly when the battery is being discharged.Īfter the battery is fully discharged, the base will then charge the batteries. This indicates that you now have 5 seconds to place the mouse in the charging base for battery discharge. The red light will flash quickly when you press the battery discharge button on the bottom of the base. The red light is for indicating discharge status of NiCad batteries. The older NiCad batteries needed to be conditioned occasionally so Kensington provided a way to do that with the charging base. When this mouse was manufactured it used NiCad batteries which developed a memory much more than the newer batteries. If this procedure does not resolve your issue to try a system reset. The headset and base should now be connected.ħ. Remove the headset from the charging base lift telephone handset/press headset button if not using a handset lifter. Resubscription is finished when the red light on the base is fully illuminated and the green light on the headset disappears.Ħ. Press the mute switch (black wheel on the top of the headset) straight down until a green light appears on the headset, then let go of the wheel, and the light should remain on the headset.ĥ.

The red light should continue to flash.Ĥ. Press and hold both the + and - buttons on the back of the charging base until the red light on the front of the base starts to flash.ģ. Return the headset to the charging base.Ģ.

However, if you wish to use a replacement headset with the base unit (or if you lose your connection to the base unit), then you must re-subscribe as follows:ġ. The headset and the base unit are supplied subscribed to each other.

This is correct, additionally you can use a handset lifter accessory, such as the HL1 or HL10. Please note that your hand receiver has to be off the hook when using the headset.

Microsoft wireless mouse 3500 connect button